Textured rubber Tractiongrips brand grips for Kel-Tec P3AT and P-32 pistols Parts list: 1. Large panel wraps from the front of the grip on the P11 And PF9, And from the back on P32 and P3AT. 2. Small strip fits under trigger guard. Directions: 1. Clean Pistol grip with hot water and a drop of dish detergent. Dry with hot hair dryer. 2. Line parts up before removing backing to determine placement of grip panels. 3. Remove backing and stick grips on pistol, using caution to avoid touching the adhesive backing. 4. Use hair dryer to heat and soften grips, then smooth grips down with fingers. A pencil eraser can be used to press material into texture and smooth edges down. Rubber grips may feel slippery until heat is applied to evaporate any mold release agent on the surface of the grips. 5. Use caution when cleaning the gun as some solvents may dissolve the adhesive causing the grips to peel off.